PNG  IHDR;IDATxܻn0K )(pA 7LeG{ §㻢|ذaÆ 6lذaÆ 6lذaÆ 6lom$^yذag5bÆ 6lذaÆ 6lذa{ 6lذaÆ `}HFkm,mӪôô! x|'ܢ˟;E:9&ᶒ}{v]n&6 h_tڠ͵-ҫZ;Z$.Pkž)!o>}leQfJTu іچ\X=8Rن4`Vwl>nG^is"ms$ui?wbs[m6K4O.4%/bC%t Mז -lG6mrz2s%9s@-k9=)kB5\+͂Zsٲ Rn~GRC wIcIn7jJhۛNCS|j08yiHKֶۛkɈ+;SzL/F*\Ԕ#"5m2[S=gnaPeғL lذaÆ 6l^ḵaÆ 6lذaÆ 6lذa; _ذaÆ 6lذaÆ 6lذaÆ RIENDB` LOCATION -------- Read-only location of a target on disk. For an imported target, this read-only property returns the value of the ``LOCATION_`` property for an unspecified configuration ```` provided by the target. For a non-imported target, this property is provided for compatibility with CMake 2.4 and below. It was meant to get the location of an executable target's output file for use in :command:`add_custom_command`. The path may contain a build-system-specific portion that is replaced at build time with the configuration getting built (such as ``$(ConfigurationName)`` in VS). In CMake 2.6 and above :command:`add_custom_command` automatically recognizes a target name in its ``COMMAND`` and ``DEPENDS`` options and computes the target location. In CMake 2.8.4 and above :command:`add_custom_command` recognizes :manual:`generator expressions ` to refer to target locations anywhere in the command. Therefore this property is not needed for creating custom commands. Do not set properties that affect the location of a target after reading this property. These include properties whose names match ``(RUNTIME|LIBRARY|ARCHIVE)_OUTPUT_(NAME|DIRECTORY)(_)?``, ``(IMPLIB_)?(PREFIX|SUFFIX)``, or "LINKER_LANGUAGE". Failure to follow this rule is not diagnosed and leaves the location of the target undefined.